Windows Media Encoder problem: wireless router is not letting my broadcast go thru?

I have downloaded the Windows Media Encoder. It apears that my wireless router is not letting my broadcast go thru.

Has anyone had any problems doing this

[Stream Ripper]

I have not used it myself before, but did you check to make sure it's allowed in your firewall or firewallS?

Stream Ripper, thanks for the prompt reply

I have disabled all firewalls. I think it has to do with my IP address. They have a link to see what IP address that you are using when in the "Cam streams", it shows a different than when I use the Command prompt. I tried to change it on the "Cam streams" but it won't let me. It is hard to explain, not less you are in this Cam stream site.

I think the bottom line; I just don't understand what going on. If a guru could take a look, they most likely can figure it out.

Any help would be great

Thanks
Joe

Have you tried to broadcast through a wired connection? Do you have the same problem?

Do you have a firewall in your router?